VISIBLE CABLE INSTALLATION

VISIBLE CABLE INSTALLATION PROCEDURE

1. Make a hole in the wall or use an already existing one.

2. Remove the glass from the aesthetic cover, by gently pressing all along the perimeter in order to disengage it from the magnets.

3. Disengage the aesthetic cover by gently pressing on the rear panel.

Elica Snap

4. Disconnect the connection cable inside the aesthetic cover.

5. Choose which side you want the cable to go through, and therefore cut out the rear body in the corresponding point.

Elica Snap

6. Prepare what is needed for fixing the appliance:

a) Position the rear body on the out-let hole (6a)

b) Use the rear body as a template to mark the fixing holes (6b)

c) Drill the 4 holes in the wall, according to the marks, and insert the anchors (6c)

Elica Snap

7. Remove the closure piece of the frame.

Elica Snap

8. Position the frame based on the direction chosen for the cable to go through.

Elica Snap

9. Position the electric cable according to the following solutions.

Elica Snap

10. Position the frame and the rear body, and fix to the wall with the screws.

11. Insert the supplied cable clamp.

Elica Snap

12. Refit the aesthetic cover and connect the electronics of Snap.
Warning! Arrange the electronic wires in such a way that they do not get stuck during closing.

13. Hook the aesthetic cover to the frame. Gently press on the entire perimeter.

Elica Snap

14. Refit the glass on the aesthetic cover.

15. Connect the cable to the socket.

Elica Snap

Snap is now ready to be configured.
Go to the configuration procedure.

Watch the video of installation and configuration

Didn't find what you are looking for?

Contact us

Close