- Hoods
- Aspiration hob
- Hobs
- Other products
1. Make a hole in the wall or use an already existing one.
2. Remove the glass from the aesthetic cover, by gently pressing all along the perimeter in order to disengage it from the magnets.
3. Disengage the aesthetic cover by gently pressing on the rear panel.
4. Disconnect the connection cable inside the aesthetic cover.
5. Choose which side you want the cable to go through, and therefore cut out the rear body in the corresponding point.
6. Prepare what is needed for fixing the appliance:
a) Position the rear body on the out-let hole (6a)
b) Use the rear body as a template to mark the fixing holes (6b)
c) Drill the 4 holes in the wall, according to the marks, and insert the anchors (6c)
7. Remove the closure piece of the frame.
8. Position the frame based on the direction chosen for the cable to go through.
9. Position the electric cable according to the following solutions.
10. Position the frame and the rear body, and fix to the wall with the screws.
11. Insert the supplied cable clamp.
12. Refit the aesthetic cover and connect the electronics of Snap.
Warning! Arrange the electronic wires in such a way that they do not get stuck during closing.
13. Hook the aesthetic cover to the frame. Gently press on the entire perimeter.
14. Refit the glass on the aesthetic cover.
15. Connect the cable to the socket.
Snap is now ready to be configured.
Go to the configuration procedure.